• Fairfield, CA 94533
  • CA Lic. #1149164
  • Free estimates
  • Se habla español
goldrrremodeling2@gmail.com

Tile installation in Fairfield, CA

  • Licensed CA general contractor #1149164
  • Free estimate
  • Se habla español

Tile is a big part of what we do. We set tile in showers, on bathroom and kitchen floors, on backsplashes and on stair treads for homeowners in Fairfield and the surrounding cities.

A tile job is decided before the first tile is set. If the surface underneath moves, holds water or is out of flat, the tile on top will crack, come loose or look crooked. So a lot of our time goes into what you will not see: backer board, a sloped shower pan, waterproofing, an uncoupling membrane on floors, and a layout worked out before any thinset is mixed. We have more than 13 years of experience doing it this way, under California contractor license #1149164.

How we set tile

Preparation first. In a shower, the walls get cement backer board and the floor gets a sloped mortar bed with a PVC pan liner. Then we roll a waterproofing membrane over the walls, niche, bench and curb. On floors outside the shower we put down an uncoupling membrane, which lets the tile and the subfloor move a little without cracking the tile or the grout.

Layout second. We measure the room, find the center, and dry-lay a row to see where the cuts fall. The goal is balanced cuts at both ends of a wall, no thin slivers at the ceiling or in a corner, and grout lines that carry through a niche and around a window. With large-format tile we check that each piece is fully bedded in thinset, and we use leveling clips while it cures.

Cuts are made with a wet saw, outside when possible, and edges that show are finished clean. We keep the work area swept and wipe down the tile as we go. What we are after is a surface that is flat, lined up and ready to use once the grout has cured.

Tile shower wall with a stacked double niche and pebble floor
Tile shower wall with a stacked double niche and pebble floor

What is included

  • Tile showers

    Walk-in showers tiled floor to ceiling, with recessed niches, benches and curbs wrapped in tile. Every surface is waterproofed before tile goes on.

  • Shower pans

    A sloped mortar bed with a PVC pan liner, built on site and pitched to the drain, ready for pebble stone or small tile that follows the slope.

  • Floor tile

    Large-format porcelain over an uncoupling membrane, set with a leveling-clip system so one edge does not sit higher than the next.

  • Tiled stairs

    Stair treads tiled in the same porcelain as the floor, cut to each step and set with leveling clips so the front edges stay straight.

  • Backsplashes and walls

    Subway tile and other wall tile, centered on the wall, with tight cuts around outlets, windows and cabinets.

  • Surface preparation

    Cement backer board in wet areas, a roll-on waterproofing membrane, and floors checked for flat before anything is set.

  • Grout and finishing

    Joints are grouted full, corners and changes of plane are caulked, and the tile is cleaned of haze before we leave.

Tile, grout and layout options

Every project is completed using the appropriate materials. That means the right thinset for the tile and the surface, grout suited to the joint width, and waterproofing wherever water reaches.

You choose the tile. We tell you what it needs. Large tiles need a flatter floor. Pebble stone takes more grout and a little more care. Small tile follows a shower slope better than big tile does.

  • Large-format porcelain
  • Subway tile, stacked or offset
  • Pebble-stone shower floors
  • Recessed niches and tiled benches
  • Tiled stair treads
  • Kitchen and bathroom backsplashes

Timing

Tile timing depends on the size of the area, the amount of prep, and the cure times for mortar, waterproofing and grout. A backsplash and a full shower are not the same job. We give you the expected timing in writing with your estimate, and we do not skip cure times to finish sooner.

Shower wall tile being set with spacers over a finished pebble shower floor
Shower wall tile being set with spacers over a finished pebble shower floor

Our Tile Installation work

See all projects

Questions about Tile Installation

Can you tile over my existing tile or floor?

It depends on what is there. Tile is only as good as what is under it. We look at the existing surface during the free estimate and tell you if it can stay or needs to come out.

Why do you put an uncoupling membrane under floor tile?

Floors move a little with temperature and with the house. The membrane sits between the subfloor and the tile and takes up that movement, so it does not travel into the tile and crack it or the grout.

Is a pebble-stone shower floor a good idea?

It works well when it is built right. The stones follow the slope of the pan, and the extra grout lines give you grip underfoot. It takes more grout than flat tile and needs regular cleaning. We can show you photos of ones we have built so you can decide.

What is a leveling-clip system?

Clips and wedges that hold neighboring tiles at the same height while the thinset cures. With large-format porcelain, a small difference between two edges is easy to see and feel. The clips keep the surface flat, and they come off before grouting.

Do you install tile I already bought?

Yes. Tell us what you have and how much, and we will check it against the area during the estimate. We are based in Fairfield and also install tile in Benicia, Vallejo, Napa and other nearby cities.

Let's make your dream a reality. Let's work together.

Free estimates across Fairfield and the North Bay. Call, text, or send the form with a few photos.

GOLD R R REMODELING, CA Lic. #1149164

Text us