Finish carpentry and trim in Fairfield, CA
Trim is the last thing to go in and the first thing people notice. Baseboards, casing and crown cover the gaps where floors, walls and ceilings meet. When the joints are tight and the lines are straight, the whole room looks finished. When they are not, no amount of caulk hides it.
Gold R.R Remodeling installs baseboards, crown molding, doors, trim and custom wood details in Fairfield and nearby cities such as Vallejo and Napa. We hold CA General Contractor License #1149164 and have more than 13 years of experience. The crew is small and the owner works on the job himself. Estimates are free.
How we install trim
No house is perfectly square, so we measure each wall and corner on its own instead of assuming ninety degrees. We check the floor for dips and the walls for bows before cutting. That tells us where a baseboard needs to be scribed to the floor and where a casing needs a shim behind it.
Inside corners on baseboard and crown are coped. One piece runs square into the corner and the other is cut to the profile so it fits over the first. A coped joint stays closed when the wood moves and when the corner is not square, where a plain inside miter tends to open up. Outside corners are mitered and glued.
We nail into framing, not only into drywall. Then we set the nails, fill the holes and caulk the top edge where trim meets the wall. Cutting is done outside or in the garage when possible to keep dust out of the house. Keeping the work area clean is one of our priorities.

What is included
Baseboards
New baseboard after a flooring job or to replace damaged runs. Inside corners are coped, outside corners mitered, and the bottom edge is scribed where the floor is uneven.
Crown molding
Measured, cut and fitted to your actual walls and ceiling, which are rarely square. Long runs are joined with an angled scarf joint over a stud, placed where it is least visible.
Doors
Replacing door slabs or prehung units. We set the jamb plumb, keep the gaps even around the door and make sure it latches without rubbing.
Door and window casing
Casing around doors and windows, with mitered corners that close tight and an even reveal along the jamb.
Custom carpentry
Wood details built to fit your room, such as shelves, wall trim and other pieces made on site. Tell us what you have in mind and we will tell you what is practical.
Fill, caulk and cleanup
Nail holes filled, joints caulked, surfaces left ready for paint. Offcuts and old trim are hauled away.
Materials and profiles
Trim comes in paint-grade material, like primed MDF, finger-jointed pine or poplar, and in stain-grade solid wood. Stain-grade shows the grain, so the joints and the wood selection need more care.
If we are matching trim in an older home, we take a sample or a tracing of your existing profile and look for the closest match available. Every project is completed using the appropriate materials, including moisture-resistant trim for bathrooms and other damp rooms. We review the options with you at the estimate.
- Primed MDF for painted trim
- Finger-jointed pine or poplar
- Stain-grade solid wood
- Flat modern profiles or traditional profiles
- Crown molding in one piece or built up
- Filled, caulked and ready for paint
Timing
Timing depends on how many rooms, how much trim and whether doors or custom pieces are part of the job. Material that has to be ordered can also affect the start. We give you the expected timing in writing with your free estimate.

Questions about Finish Carpentry
My walls and floors are not straight. Can trim still look right?
Yes. That describes most houses. We scribe baseboard to follow the floor, shim casing where the wall bows, and split the difference where a ceiling runs out of level so the eye does not catch it. A thin line of caulk at the wall finishes the job. Caulk should never be doing the work of a bad cut.
Can you match the trim I already have?
Usually we can get very close. For an older or unusual profile we look for the closest stock match, and we tell you up front if an exact match is not realistic so you can decide whether to replace the whole room.
Do you paint the trim after installing it?
We fill, caulk and sand so the trim is ready for paint. Painting can be included in the same estimate if you want one crew to handle both.
Do you install baseboard after new flooring?
Yes, and that is the right order. Flooring goes in first, then the baseboard sits on top and covers the expansion gap. We install floors too, so for homes in Fairfield and the surrounding area both jobs can be scheduled together.
Where we do this work
Finish Carpentry in Fairfield and across Solano, Napa and Sonoma counties:
Other services
Let's make your dream a reality. Let's work together.
Free estimates across Fairfield and the North Bay. Call, text, or send the form with a few photos.
GOLD R R REMODELING, CA Lic. #1149164
